Water-Based Release Agent for Carbon Fiber Tubes
A water-based release agent for carbon fiber composite and epoxy resin moulding systems. It is used for filament-wound and compression-moulded carbon fiber products.
Product Data
- Type
- Water-Based
- Application Range
- Carbon fiber composite and epoxy resin moulding applications
- Dilution Ratio
- 1:5 to 1:15
- pH
- 6-8
- Operating Temperature
- 70-250°C
- Product Type
- Carbon Fiber Release Agent
- Applicable Formwork / Mould
- Moulds for filament-wound and compression-moulded carbon fiber composite products
- Application Method
- Clean and dry the mould, wipe or spray evenly over the complete surface, and allow approximately 5-10 minutes drying time.
- Packaging
- 25 kg/drum; 50 kg/drum; 200 kg/drum
- Storage
- Store indoors away from sunlight and rain; protect from freezing; keep unused material sealed.
- Shelf Life
- 2 years
- Additional Notes
- PDF appearance descriptions conflict and therefore Appearance is intentionally left blank. Viscosity: 9 s; density: 0.98-1.02; freezing point: -7°C.
Product Overview
This product supports demoulding of carbon fiber tubes, rods and other composite components. It can be wiped or sprayed over a clean, dry mould surface and diluted with water where required.
Product Features
- Suitable for manual or mechanical spraying.
- Designed for carbon fiber composite and epoxy resin systems.
- Can be diluted for mould application.
Applications
Carbon fiber tubes, badminton rackets, fishing rods, golf clubs, arrow shafts, bicycles, helmets, paddles, automotive hoods and composite housings.
Application Method
Clean and dry the mould. Wipe or spray the release agent over the entire surface without gaps, then allow approximately 5-10 minutes drying time according to ambient conditions.
Storage & Packaging
Packaged in 25 kg, 50 kg and 200 kg plastic drums. Store indoors away from sunlight and rain and protect from freezing. Shelf life: 2 years.
Precautions
Keep unused material sealed to prevent water and impurities from entering. Use in a ventilated area when cleaning the mould.
Applications
Clean and dry the mould, wipe or spray evenly over the complete surface, and allow approximately 5-10 minutes drying time.
Related Products
Concrete Mould Release Agent
View product details.
VIEW PRODUCT →
Water-Based Release Agent for Precast Concrete
A water-based releas…
VIEW PRODUCT →
Concentrated Water-Based Release Agent for Precast Concrete
A concentrated water…
VIEW PRODUCT →
Oil-Based Release Agent for Precast Concrete
An oil-based release…
VIEW PRODUCT →Discuss This Product
Send the product and requirement details for follow-up.